Design Bridges using OpenBridge - Level 1 + LumenRT -AulaGEO

Level 1 of Bentley Open Bridge is a beginner's guide, where we learn the basics of this software. Starting with a short theoretical session, we assume that you have basic know how about bridges, after quick review of some common terms we will get familiar with the interface of Bentley Open Bridge.

After brief introduction, we will proceed with an exercise in which we will create Precast Girder 2 Span Straight Bridge Model. In process of making this bridge we will learn multiple procedure like adding a bridge Model, support Lines, bridge Decks, Girders, placing and Modifying Piers, Abutments, Bearings an Barriers.

After successful creation of Precast Girder 2 Span Straight Bridge Model using conventional method, we will learn how to make the same using Wizard method which is way more convenient and gets results with just few clicks and inputs. After that you can compare both models at your own convenience.

#AulaGEO Course content:

Lesson 0 Theory

Getting Started

Lesson 1 Introduction

Lesson 2 Initiating Open Bridge Modler from Open Bridge Designer

Lesson 3 User Interface

Lesson 4 Importing .tin file (Terrain Model)

Exercise: Precast Girder 2 Span Straight Bridge Model

Lesson 5 Adding a bridge Model

Lesson 6 Adding Support Lines

Lesson 7 Adding Bridge Decks

Lesson 8 Adding Girders

Lesson 9 Placing and Modifying Pier

Lesson 10 Placing Abutments

Lesson 11 Placing Bearings and Stepped Cap

Lesson 12 Placing Barriers

Exercise: Precast Beam 2 Span Straight Bridge Model – Using Wizard

Lesson 13 Adding Bridge Model

Lesson 14 Place Excavation

Lesson 15 Place Diaphragms

The course includes LumenRT using an OpenBridge model.